When choosing an energy chain bend radius, use the largest minimum bend radius required by any enclosed cable or hose as a baseline, then select a larger chain radius to provide a margin. The total height of the bent chain must also be less than the height available in the equipment.
The largest bend radius requirement sets the minimum
An energy chain may contain electrical cables, pneumatic hoses, or other lines. Consider the minimum bend radius of each one, use the largest requirement as the baseline, and allow a margin. Choosing a radius based only on a more flexible cable could bend other lines too tightly.
Use the total bend height to check available space
The total height of the bent chain can be calculated as “2×bend radius+chain outer height.” The larger the radius, the more height is needed. The selected radius must meet the requirements of the enclosed lines while keeping the calculated total height below the available equipment height.
Example: how much height does a 75 mm radius require?
For example, a plastic energy chain with a bend radius of 75 mm and an outer height of 55 mm has a total bend height of 75×2+55=205 mm. If the equipment has 220 mm of height available, the chain will fit vertically. Whether this radius is suitable also depends on the minimum bend radius requirements of the enclosed cables and hoses.