How to choose between jaw and Oldham couplings: comparing torque, misalignment and construction

First, narrow the options by drive requirements

For spindle drives requiring high speeds, high torque or forward and reverse rotation, consider the DLZ expansion-locking jaw coupling. Its central elastomer absorbs vibration, while the expansion-locking design provides zero backlash. If the priority is compensating for radial and angular misalignment between two shafts, consider the DHP Oldham coupling, whose sliding mechanism is designed to accommodate both. After narrowing down the options, select a specific model based on actual torque and speed.

Select models by operating torque and speed

List the equipment's operating torque, peak torque and speed, then compare them with the candidate models. For example, the DLZ-55×78 has a rated torque of 55 N·m and a maximum torque of 90 N·m; the DHP-12×14.2 has a rated torque of 1 N·m and a maximum speed of 9000 r/min. These are two different sizes: if the application's rated torque exceeds 1 N·m, the DHP-12×14.2 should not be selected; whether the DLZ-55×78 meets the speed requirement must be determined from its speed specification.

Compare radial and axial misalignment separately

Record the expected radial and axial misalignment between the two shafts and compare each with the model's permissible values. The DLZ-55×78 has a radial misalignment specification of 0.1 mm and an axial misalignment specification of 0.5 mm; the DHP-12×14.2 allows 0.3 mm of radial offset and 0.2 mm of axial misalignment. Of these two models, the former has a higher axial misalignment specification, while the latter allows greater radial offset. Choose based on the equipment's actual misalignment rather than looking at just one value.

Then compare mounting methods and materials

Once the shaft mounting method and operating environment are established, compare the designs. The DLZ has an aluminum alloy expansion-locking structure and a central polyurethane elastomer that resists wear and oil and provides electrical insulation. The DHP set-screw series has a SUS304 stainless steel body and a POM adjustment ring, offering wear and corrosion resistance. If expansion-locking mounting and elastomeric vibration damping are needed, consider the DLZ first; if set-screw mounting and a stainless steel body are needed, consider the DHP first.

Products in this article

DLZ aluminum alloy expansion-locking jaw coupling

DHP stainless steel high-torque Oldham coupling, set-screw series

Back to articles