How to Choose a Timing Belt Backside Tensioner: Pulley Surface and Placement

A Smooth Pulley Can Contact the Back of the Timing Belt

Backside tensioning is a form of outside tensioning. Because the tensioner contacts the back of the timing belt, it does not need teeth, so a smooth pulley can be used. First determine whether the pulley contacts the back or the toothed side of the belt, then select the appropriate pulley surface.

Place the Tensioner on the Slack Side

Once backside tensioning has been selected, position the tensioner on the slack side of the timing belt. This reduces the difference in compliance between the slack and tight sides during startup, reducing the likelihood of tooth skipping.

Do Not Apply the Inside Flat Idler Diameter Requirement to a Backside Tensioner

In certain inside-tensioning applications using a flat, toothless idler, the pulley diameter must be at least 40 times the belt tooth pitch. This requirement applies to inside tensioning and cannot be used directly as a diameter rule for backside tensioners.

Back to articles