How to choose a ball screw support unit: determine the mounting arrangement first, then match the shaft diameter and operating conditions

Determine the unit type according to the ball screw support arrangement

First consider the machine structure and the ball screw’s operating requirements, then choose a support arrangement: fixed at one end and free at the other is a simple configuration suited to short strokes or vertical drives, but it provides lower axial rigidity and a lower critical speed; fixed at one end and supported at the other is suitable where a certain level of speed, rigidity, and precision is required; support at both ends can be used for general operating conditions; fixing both ends is suitable for high axial loads, higher axial rigidity requirements, or high-speed, high-precision applications. After determining the arrangement, select the corresponding fixed-end and support-end unit types.

Match the support unit size to the ball screw support shaft diameter

Choose the size according to the shaft diameter at the ball screw’s support end, not just the lead or the nut’s exterior dimensions. Common standard types include fixed-end units AK, BK, EK, and FK, and support-end units AF, BF, EF, and FF. The nominal shaft diameter in the unit type specification corresponds to the inner diameter of the fixed-end bearing housing, so it should match the ball screw shaft-end dimensions. If the ball screw has not yet been selected, first determine its size based on the machine’s space constraints and transmission requirements, then select the support unit according to its shaft-end dimensions.

Select a support configuration based on actual thrust and speed requirements

Compile the machine’s load, operating speed, and motor output torque. If a reducer is used, include its effect on transmission when assessing thrust. Then use the dynamic load ratings in the ball screw catalog to select a ball screw size, and compare unit types according to the target support arrangement. For short strokes or vertical drives, first consider the simple arrangement of a fixed end and a free end. If greater rigidity or high-speed, high-precision performance is required, consider adding support at the other end or fixing both ends.

Precision and environmental requirements determine the choice of grade and material

The support unit precision should match the ball screw precision: relevant selection guides recommend a C-grade support unit for a C3-grade ball screw, a C5-grade or C3-grade support unit for a C5-grade ball screw, and a C7-grade support unit for a C7-grade ball screw. For the operating environment, consider corrosion-resistant materials where there is moisture or chemical exposure; aluminum alloy for lightweight equipment; and carbon steel, which offers good strength and wear resistance, for high-load, frequent-use applications. First meet the requirements for support arrangement, shaft diameter, and precision, then choose the material based on environmental and weight requirements.

Back to articles